Separate servo power supply and control board power supply, independent power supply
Control channel: Control 32 channels at the same time. (Servo speed adjustable)
Communication input: USB or serial port (TTL)
Signal output: PWM (accuracy 0.5us).
The baud rate range: 9600 19200 38400 57600 115200 128000.
Supported steering gear: Futaba, Hitec, Frasun, Spring, etc. More than 98% of servos on the market
PCB size: 63.5mm x 43.5mm.
Installation hole spacing: 55*35.5mm.
Storage: Onboard 16M USB flash drive.
Controlling MCU power supply: 6.5~12 V or 3.5~5.5V. (USB can be used to power the chip on servos board. And it can be chosen automatically. With the USB reverse protection, it can protect your computer from been hurted by the reverse USB.)
– Servos power supply: DC (depends on the motors, generally 5V DC)
– Control channels: 32. (can be controlled at the same time and the accuracy can be adjusted)
– Communication Input: USB or UART (TTL or USART). (The Bluetooth or some other wireless module can be used to make the controlling)
– Signal Output: PWM (Accuracy 1us).
– Servo motor resolution: 1us, 0.09 degrees.
– Baud Rate: 9600,19200,28400,57600,115200,128000(recognized automatically)
– Servo motors supported: Futaba, Hitec or some other Servos Motor controlled by PWM.
– Dimensions: 63.5mm x 43.5mm x 1.6mm.
– Control mode: USB and UART (TTL) to accept command. (Comes with USB data wire and PC controlling software)
– Flash memory: onboard 512K ROM (If every command is used to control the 24 motors at the same time, more than 500 commands can be saved.)